Lol well I’d prefer to have the 3rpm but i’d be fine without seals if neededI hate to be that guy but.....
You both have sealed lids and you both have the 3 RPM motors. Just a friendly observation so be nice
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Lol well I’d prefer to have the 3rpm but i’d be fine without seals if neededI hate to be that guy but.....
You both have sealed lids and you both have the 3 RPM motors. Just a friendly observation so be nice
Thank you for the friendly observation . What’s your working hypothesis?I hate to be that guy but.....
You both have sealed lids and you both have the 3 RPM motors. Just a friendly observation so be nice
Thank you! That was one change that I made a few weeks ago, but forgot to mention earlier. Just checking.Negative
Remove the 3 RPM motorThank you for the friendly observation . What’s your working hypothesis?
Imagine if you will, a world where a bunch a folks purchased 3 RPM motors then flooded the seller with calls. I bet said vendor would probably stop selling above mentioned 3 RPM motors.Thank you for the friendly observation . What’s your working hypothesis?
If the 1250 is pretty much the same as the 700 but has the 3rpm which as far as ive seen without issues than why would that cause issues on 700?Remove the 3 RPM motor
That’s a good thought, but the motor is one thing that hasn’t changed since day one of grill ownership. What are your thoughts as to why the temps were steady with the 3 rpm motor until yesterday?Remove the 3 RPM motor
That’s an excellent point, but possibly a separate issue?Imagine if you will, a world where a bunch a folks purchased 3 RPM motors then flooded the seller with calls. I bet said vendor would probably stop selling above mentioned 3 RPM motors.
Strictly speculation on my part.
IMO they stopped the sale of the 3rpm by itself because they need to either make sure they have enough for the newly made 1250s and possible issues with people who purchased it or to not make it so simple to get what a 1250 has out of a 700Imagine if you will, a world where a bunch a folks purchased 3 RPM motors then flooded the seller with calls. I bet said vendor would probably stop selling above mentioned 3 RPM motors.
Strictly speculation on my part.
I reject your reality and substitute my ownThat’s an excellent point, but possibly a separate issue?
Different controller firmware?If the 1250 is pretty much the same as the 700 but has the 3rpm which as far as ive seen without issues than why would that cause issues on 700?
Idk what they did or didn’t do but that Make sense tooDifferent controller firmware?
So I just ran a quick test. 90* or so dayDifferent controller firmware?
Sure doesn't sound like a lid seal issue?So I just ran a quick test. 90* or so day
Set grill at 225 and was doing its bouncing around.
Cranked it up to 350 and was dead on for about an hour straight
Dropped it to 275 for 40min and was dead on.
Brought it to 250 and it was moving a few degrees up and down the whole time.
Back to 225 and all over again.
So I’m going to say with current temp here and the 3rpm 15 might be a better setting if im trying to keep lower temps like that.
Well if it is. Its because my lid seals are offended by lower temps so they screw things up until the temp risesSure doesn't sound like a lid seal issue?
Seals are sensitive creatures.Well if it is. Its because my lid seals are offended by lower temps so they screw things up until the temp rises
Seals are sensitive creatures.
That's ...That's ... it's.... Sammy the sensitive smoking seal