Stampede Help please: Messed up auger setting

[Kanco Connection]

Hello all—I inadvertently altered the auger setting on my 590. I got into the settings to make an adjustment to the offset temp (my trusted ThermoWorks reading 275 when RT set to 250) and started turning the dial and then realized I was on the auger setting. I don’t know where I started on the auger setting or where I landed or what I did to it. Is there a factory reset so I can start over? I’m not even sure what the auger setting does or what adjustment I might need to make to it at this point. Kind of lost now. Appreciate any help here. Thanks.

 

[Greg Jones]

The ‘Operating your grill’ settings section explains how to reset the feed rate to the factory setting. As far as i know, there is not master reset of all the default settings.

 

[Kanco Connection]

Thank you. I found it. (factory preset = 30). I appreciate the help.