I line my drip pan with heady duty foil and usually only clean once the soot starts piling up so much that I start getting black spots on my food from the splatter. A lot of it depends on how fatty the foods that I've been cooking not necessarily the number of cooks, but I would say I do deep...
Rec Tec created the specs, then the manufacturer builds it to spec, it was probably a bean counter decision. I've noticed most power cords have gotten shorter, cheaper-made, and less flexible for all electronics as of late.
Eric, I have an RT-700 and also had some grease leakage. I agree, we shouldn't have to rely on gasket sealer, the barrel is tack welded and some areas have larger gaps. I had to wipe down the inside after a few cooks to apply more Permatex - quite annoying. Walmart carries the stock Permatex for...
Was the 12 7/8 dimension tight, any extra space? I debating if I should go with 12 3/4 like this guy with a bit space for expansion? https://www.recteqforum.com/threads/heat-deflector-mod-improvement-etc.4194/
Appreciate you taking the time to reply and you attached a picture too! The stainless versions is 9 1/4" wide, but the base is 11" They probably split the difference for stability. I'm contemplating make a plate 11" wide, which is the same as the base. My thinking is that a slightly wider...
I store my pellets in my basement since it's cooler and the temps are even with very little humidity, that being said I had the same concern as you and I've had a dozen bags in my basement over two years now and no issues what-so-ever.
Hello, I'm curious to know if the width of the cast iron heat deflector shield is the same as the stainless one from the RT-700? If it's not too much trouble could someone that owns the RT-1250 post the width from left to right of the deflector installed?
Thanks in advance.
If it's not too much trouble can you tell me the width left to right when installed of the cast iron deflector for your 1250? I'm curious to know if it's the same width as the stainless one in the RT-700.
Thank you.