Recent content by t3dfx

That's right Greg, I agree with you. Sorry, I didn't think any further.

What I just remembered. Does the sear kit have an influence on the fact that the displayed temperature is not so high? I could well imagine that in terms of circulation. Or should the temperature be higher here? Maybe I have to look for my laser thermometer. I think the correct values must be...

Okay, thanks again for your support. I will call RT, I also had a conversation with a friend, he has 2 other brands, where we will then test again. I keep you guys up to date! Greetings

I will test how high the RT-680 comes, but here I had no problems as I said, but also very rarely run so high. With the old pellets from RT yes, but with the new brand not yet. Fan runs perfectly, is also clean. Also the holes in the pot as well as the passage from fan to pot is clean. If I do...

Yes I use. I don't have any problems with the 680, but its temperature doesn't go nearly as high. I only have problems at the maximum temperature at the 380, the temperature curve is absolutely even. My thermometers are also correct, have already tried several here, the range to the sensor in...

Thank you for your answers. Yes the lid spacer is installed from the beginning. The pot is also clean and is always cleaned out before starting. I thought I would use the pellets that are recommended. Had also already opened a second bag and used those. But here was the same problem. Then I...

Hello together! I have to ask. You write that you get temperaturn in riot mode up to 749 °F and more. Unfortunately, this does not happen at all for me. Maximum temperature is around 520 °F. The bullseye is clean, the vents are always cleaned from dirt before the start. I have the firmware...