Bullseye While on LO setting, got Er2 on the Bullseye

[smovider]

Hopefully not to silly of a question, but temp outside is about 58 degrees f, overcast with a slight brreze.

I exeperienced this last saturday while smoking some beef shorts, cleaned the short RTD while I was cleaning out the firepot.

Maybe I'm using this fine cooking instrument incorrectly, but would like to verify it's me and not the device.

BTW, I did experience an Er2 while in lo for 1.5 hours, went down to 138 Degrees F, then Er2. Shut off the PID, and it fired back up, so I'm pretty sure the hot rod is OK.

 

[RattleR]

It sure if this will helphttps://support.recteq.com/hc/en-us/sections/4417494801051-Error-Codes

 

[Buckeye1]

In my experience:
1. Pot full of ash above or equal to igniter
2. Vents no clean
3. Bad pellets - crumble to dust easily

The bullseye is more fickle than my trailblazer for sure.

 

[smovider]

Brian K. from RecTeq helped me calibrate my 380.

Big Thanks to him for helping me out. My Bullseye is now within 10 degrees of temp