Bullseye Naked Bullseye Pic

[C. Keeper]

This is how you get to the RTD. A 7mm socket is needed to prevent the nuts from spinning when removing screws from bowl.
Wish my sensor would get here, I'm ready

 

[Sscottfitz]

This is how you get to the RTD. A 7mm socket is needed to prevent the nuts from spinning when removing screws from bowl.
Wish my sensor would get here, I'm ready
View attachment 7542

I recognize that picture, I had to do the very same thing, but I had to cut the tie wraps so I could get enough play in the "red & white" ignitor wires, to re-seat the ignitor...... Good luck, it actually went back together better than I thought it would.......

 

[C. Keeper]

I recognize that picture, I had to do the very same thing, but I had to cut the tie wraps so I could get enough play in the "red & white" ignitor wires, to re-seat the ignitor...... Good luck, it actually went back together better than I thought it would.......

I had to cut 2 cable ties and able to snake wire behind existing tie. I'm not looking forward to starting the 7mm nuts for the RTD.