Recent content by Jeremy31

That is not how the hinge should fit the lid on the original Bullseye, that notch on the upper hinge should fit around the lip on the lid

Something like https://www.amazon.com/KAMaster-Stainless-Charcoal-Accessory-Replaces/dp/B07YXLPMC5?th=1

Try starting it at 225F, then change the temp when it starts burning good

I normally start mine up at 225, then ramp it up to whatever I want after it reaches 225

https://www.charbroil.com/21-diameter-round-porcelain-coated-grill-grate-8429433p06 might be the same

Have you ever started it with the rack and drip pan out so you can see the firepot? Mine would get a lot of pellets in the pot before ignition so I put the igniter about an eighth inch farter into the pot. Less than 9 minutes from off to 425 and it holds temp well

I have my igniter sticking out into the firepot about an 1/8 inch and mine doesn't overshoot the set temp at startup by more than 5 degrees. I had the cooking grate and heat shield off it during one startup and saw pellets getting blown to the far side of the firepot and sometimes got to about...

Oh well, still holds temp better than a PB using the same pellets

I never suggested that, someone else mentioned idle speed, even the PB is just on/off for auger and induction blower

I understand the blower is for induction but I would expect it to shut off at set point temp similar to what my father's Pit Boss Laredo does but that thing takes 30 minutes to get up to temp. I might try a recteq induction blower on it as they seem to have more CFM output

Mine doesn't even change speed even if it over shoots the set temp by 60 degrees when set at 350 or higher. Sounds like a blow torch

I know mine does on LO but when I set to 400 it can get to 450 and the fan keeps running?